Fender and Rack Installation Guide for Q7/E300

Perhaps some of you may encounter installation issues with the Q7/E300 fenders and rack. Today, I will demonstrate how to install them. You can watch the installation video on YouTube.

Installation of Front Fender:

1. Remove the battery, as installing with the battery connected may damage the bicycle.

2. Unscrew the screw securing the front light, using the same hole as the front fender.

3. Install the screws on the designated holes of the front fender. Adjust the position of the front light accordingly.

4. Install the screws on the left and right brackets of the front fender.

With these steps, the installation of the front fender is complete. It's straightforward, and you can give it a try yourself.

Installation of Rear Fender:

1. Remove the battery, as installing with the battery connected may damage the bicycle.

2. Install the screws on the frame of the rear fender.

3. Install the screws on the lower frame of the rear fender.

4. Remove the existing screws on the frame for the rear fender and replace them with the provided screws.

With these steps, the installation of the rear fender is complete. Equally simple.

Installation of Rack:

1. Locate the four corresponding holes on the rack.

2. Remove the four screws from the frame.

3. Secure the four screws in order. Then, tighten them in sequence.

These are all the installation steps for the fenders and rack. If you prefer to watch the installation video, you can follow us on YouTube. We will continuously update maintenance and accessory replacement videos for Asomtom on our YouTube channel.

YouTube video link:

https://www.youtube.com/watch?v=ES6i_LAcbz0&t=10s&ab_channel=ASOMTOME-Bikes

https://www.youtube.com/watch?v=0QDiD8C5W5g&ab_channel=ASOMTOME-Bikes